Pentair 75 User Manual download pdf (Page 19)

Rev. E 5-16-01 P/N 471105

Installation (contd.)

MiniMax 100 Electronic Direct Spark Ignition Wiring Diagram

THERMAL

FUSE

HI LIMIT SW.

PRESSURE SW.

WATER

THERMOSTAT

ON/OFF SW.

IGNITER

SPARK

MODULE

GAS VALVE

MiniMax 100 ELECTRONIC WIRING DIAGRAM

CODE OR SUPERCEDING LOCAL (WIRING) CODES.

INTERCONNECTING WIRING TO APPLIANCE MUST CONFORM TO THE NATIONAL ELECTRICAL

WIRE, 18 GAUGE, 600V, 150˚ C TEMPERATURE RATING..

THERMAL FUSE WIRING MUST BE REPLACED WITH UL OR CSA (IF CANADA) APPROVED

UL OR CSA (IF CANADA) APPROVED WIRE, 18 GAUGE, 600V, 150˚ C TEMPERATURE RATING.

IF ORIGINAL FACTORY WIRING MUST BE REPLACED, INSTALLER MUST SUPPLY

TERMINATE SUPPLY SAFETY GROUND WIRE (GREEN) HERE

GROUND SCREW WITH PAINT CUTTING WASHER

EXTERNAL

BOND LUG

CHASSIS

SHEET METAL

V2/GRD

GRN

WHT BLUE

WHT

ORN

GRN

WHT WHT WHT

WHT

ELECTRONIC

TRANSFORMER WIRING :

115V CONN

LINE : 1 & 2 (TIED)

LINE : 3 & 4 (TIED)

230V CONN

2 & 3 (TIED)

LINE : 1

LINE : 4

WHT/RED

WHT/BLK

BLK

RED

MiniMax 100 Millivolt Wiring Diagram

Remote Wiring Hook-up

The MiniMax 100 may be

connected to a two wire remote

control by disconnecting the wire

connector from the hot

(transformer) side terminal of the

"ON/OFF" switch and connecting

the two wire remote across the end

of this wire and the aforementioned

terminal.

NOTE

When connecting a remote control

to the MiniMax 100 you must install

the low voltage remote control

wires in a separate conduit from

ANY line voltage wires. Do not

exceed 25 ft. wire run for remotes

on millivolt models.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Pentair 75 User Manual Page 19

Comments to this Manuals

Related products and manuals for Water equipment Pentair 75