Pentair EQ SERIES User Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
11
EQ Series Pump Installation and Users Guide
Section 5
Maintenance
Cleaning of the Strainer Basket
1. The pump is designed to be maintenance free with the exception of requiring a periodic cleaning of the strainer
basket.
2. A routine inspection should be done by visually looking through strainer lid for debris while the pump is in
operation. The strainer basket should be cleaned when approximately 25 % blocked. Allowing the strainer
basket to become excessively blocked will diminish water flow, reduce pump efficiency, cause cavitation and
may damage the basket or other pump components.
3. Disconnect power to the pump before cleaning the basket.
4. Close isolation valves on the suction and discharge lines if necessary to prevent flooding.
WARNING The strainer pot may be at a pressure that is higher or lower than the atmospheric pressure. Always
open the drain plug on the strainer pot and allow for the pressure to equalize before removing the
locking ring. Attempting to remove the locking ring before the pressure is equalized may result in a
rapid exchange of pressure. This instantaneous release of energy can cause components to be
accelerated to high velocities and to travel distances of 100 feet or more. These components could
cause severe personal injury or death if they were to strike a person.
WARNING If the pump has been energized for a period greater than 45 minutes without water flowing through
the pump for any reason, the water in the strainer pot may be hot. Attempting to remove the locking
ring without removing the drain plug in the pot and allowing the pressure to equalize may result in
the hot water rapidly escaping and causing severe personal injury.
5. Open the drain plug in the strainer pot and allow the pressure to completely stabilize.
6. Remove the locking ring and the clear lid from the strainer pot.
7. Remove the basket and dispose of the debris. Use a water hose and soft brush to remove debris blocking the
openings in the basket if required.
8. Replace the basket making sure it is properly oriented.
9. Replace the lid, by aligning the four tabs with the tabs on the strainer pot and making sure the O-ring is clean
and is properly located in the groove of the lid.
10. Secure the lid in place by tightening the locking ring hand tight only. Do not over tighten the locking ring as that
will make removal difficult.
WARNING It is recommended that only water and a soft cloth be used to clean the lid and other pump components.
Cleaners may contain chemicals that could damage or weaken pump components causing them to
fail and allowing an instantaneous release of energy. This instantaneous release of energy can
cause components to be accelerated to high velocities and to travel distances of 100 feet or more.
These components could cause severe personal injury or death if they were to strike a person.
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comments to this Manuals

No comments